Photorealistic 3D render of a two-piece circular grey clamp with pyramid texture on its top surface, shown in isometric view.

Create a photorealistic 3D product render of a two-piece circular clamp shown in a slight isometric view. The clamp consists of two nearly identical mating halves, separated by about 3/4 inch so their geometry is clearly visible, but positioned close enough to show how they assemble together. Do not show the object being clamped; only the two clamp pieces should appear in the image. Overall geometry The clamp is designed to fit around a cylindrical object with: 4.2 inch outer diameter 4.0 inch inner diameter 2.5 inch height The clamp halves are circular ring-based parts with three equally spaced legs each. The two halves should appear as if they mate together around the object. Ring section Both clamp pieces have a ring portion with: 4.2 inch inner diameter 4.5 inch outer diameter 5/8 inch tall The ring has a beveled inner transition between the 4.2 inch inner diameter and the 4.5 inch outer diameter. The ring is a thin band with 0.2 inch radial wall thickness. The ring should fit around the unseen cylindrical object’s beveled edge geometry. Top clamp The top clamp has a separate flange/lip on top. The flange extends radially outward and must not cover any surface area of the object interior to the bevel. The flange increases the outer diameter to 6 inches. The flange is 1/4 inch thick from the tip of the pyramids to the bottom of the flange. The entire top surface of the flange is covered with small pyramids: each pyramid is 1/8 inch tall each has a square base 1/4 inch Ver más